Jaymak is a National company. Enter your postcode to find your nearest technician and request a quote.






No postcode found. Pleae try a different search
No postcode found. Please try a different search

 

ENERGY SAVINGS

Mould & Bacteria in coolrooms is a HEALTH RISK and an ADDED COST to your business!

Fan unit testing with TAFESA

On the 20th December 2007, in collaboration with the Electrical Engineering Division of TAFESA, Regency Campus and with the RD Jones Group of Hotels, testing was finalised, The testing was performed on a 3 phase refrigeration unit serving the keg room at the Tea Tree Gully Hotel, South
Australia. The unit serviced only the keg room and the following information should be taken into consideration regarding the results.

  • The condensing unit is installed in a basement area and is therefore not affected by direct sun at any time
  • The evaporator fan unit in the coolroom was a 3 fan unit
  • The second and comparative testing period was selected to:
  • Replicate the ambient conditions (less than 2 degrees difference)
  • Replicate the expected room service load (weekday)
  • The testing periods were 24 hour blocks
  • The meter used to perform the recording was a HT-HV02020E-0204
  • The recording meter was connected to the plant for approximately 1 week for each test
  • The first test ran from the 21st of November 2007 and was performed prior to the treatment of the exaporator fan unit in the keg room by Jaymak
  • The second test started on the 12th of December, immediately following the cleaning of the evaporator fan unit by Jaymak

RESULTS:
There was a significant drop in the amperage and subsequent power usage in the exaporator fans from pre-clean to post clean by Jaymak; this being a 9.4% decrease in consumption which aligns with the name plate arms.
There was also a significant decrease in condensing unit power usage after the Jaymak treatment was performed.

OVER A 24 HOUR PERIOD THIS REPRESENTS AN ESTIMATED SAVING OF 20% OR $539 pa.

Jaymak Helps You Save Energy